Vehicles
Sections
64 not categorized PORSCHE 924 ENGINE MOUNTINGSCan't find what you need? Try browsing the Accessories or Exploded Diagrams!Filtered by: 911 1974-77 (includes uncategorized and accessory items) FVD10699702 This radiator is produced by the racing & high-performance division of csf who design, engineer and manufacture the most advanced, efficient, and reliable cooling systems in the world. Csf manufacturers all aluminum high performance radiators that are a direct-fit replacement for Porsche racecars and streetcars. Csf radiators improve cooling efficiency by 10-20 % over the factory radiators. Each radiator is stamped to the same geometry and includes aluminum end tanks that offer more reliability than the factory plastic end tanks. Each csf end tank features quality welding and is generally considered the strongest tank design in the industry. If you are planning to upgrade or replace your radiators, we highly re...(choose a part on the right to read more)
$548.90
Make a selection 021105279 Resides in the front relief of the flywheel mounting surface and always overlooked, this graphite seal it the final part needed to keep the oil in the engine case one required View/Change Diagram
From $1.95
Make a selection AP958170 Agency power is proud to release its super sport exhaust system for the 958 Porsche Cayenne s v8 2011 and up. the super sport exhaust is a axle system that gives your 4.8l v8 engine a real aggressive tone. made here in the usa, the exhaust saves close to 30lbs off the rear end of the vehicle. using 304 stainless steel and detail oriented tig welding, the exhaust system uses two small high flow mufflers which give it the sports car rumble. its reduced back pressure design gives the engine improved horsepower and torque with most noticeable improvement in throttle response. because of the reduced restriction, this exhaust horsepower gains can definitely be noticed in the mid to top rpm range.
$1,495.95
Make a selection
From $2.00
Make a selection MIS100 Re-engineered and tig welded from chrome-moly steel,the quick six mounting kit enables you to immediately bolt a six-cylinder engine into your 914-4, using the factory engine pods. the '73-76 bodies, however, do require the purchase of the early rubber engine mounts. The bulkhead mount is for the serious six conversion. Welded in by a competent mechanic, it allows you to eliminate the four cylinder mounting pods allowing more clearance for valve adjust, easy removal of the rear shift bar and most importantly shifts the center of weight further forward to the factory recommended position. Powder coated finish.
$467.50
Make a selection © 2024 Automobile Atlanta Inc. 505 S. Marietta Pkwy • Marietta, GA 30060 • Order By Phone: 800 792 4944 770 427 2844 |